#300m atc code 24 manual
#300m atc code 24 code

#300m atc code 24 manual

If the ambient temperature sensor is damaged or fails, the car’s computer will not be able to automatically control the HVAC system, and the heater and air conditioner will only work in manual mode. This information is transmitted to the car’s computer, which then adjusts the climate control to meet your specifications. Prices may vary depending on your location. Its only job is to monitor air temperature (which it does through increasing/decreasing resistance in response to temperature fluctuations). On average, the cost for a Chrysler 300M Ambient Temperature Sensor (Switch) Replacement is 137 with 42 for parts and 95 for labor. I always use the manual method of setting temp and fan speed. Regardless of temperature I set, it blows cold air. The ambient temperature sensor (switch) is located either behind the front grille or in the front bumper. Replace/Remove Blend Door Problem DANNYP MEMBER 2000 CHRYSLER 300 Blend door problem Climate Control System wont heat car. In order to do this, the computer needs information about not only the temperature inside the car, but also the ambient temperature outside the car. This is done so to ensure that you get the dehumidifying effect. The arrangement of the flow is that all of the air is going through the evaporator coil and then some of the flow is pushed via the heater coil (blend door).

#300m atc code 24 code

This function basically allows you to “set it and forget it,” allowing the car’s computer to control the heating and cooling based on your preferred interior temperature. Regarding code 23 - you need to replace blend door actuator.

Today, many high and even mid-range cars offer automatic climate control. Chrysler 300M Enthusiasts Club ATC (Automatic Tempurature Contral) codes 23, 24, 32 and 33 are all displaying at the same time. The control head can only be placed into the diagnostic mode while the engine is running and the vehicle is not moving. Modern automotive HVAC systems have advanced by leaps and bounds over those used just a few years ago. I then came up with a code 24 mode door actuator feedback failure and the ducts would not switch from defrost to floor or vents. Here is the procedure: Trouble codes from the ATC control The trouble codes can be checked with the ATC control if a DRB III scan tool is not available. What is the Ambient Temperature Sensor (Switch) all about?